Twinkle has a 3D glitter effect.

Heat at 300 degress for 6 seconds. Peel off protective PET layer before cutting with vinyl cutter.

Mashine wash with garment turned inside out for long lasting results.

To successfully cut JSI Felt with your vinyl cutter:

1. Take felt off it's liner.
2. Apply felt to backer board, our felt has an adhesive so that it will stick flat to the backer board.
3. Set your cutter to slow speed and high pressure.
4. We often cut 2-5 passes with our Graphtec cutter depending on sharpness of blade.
5. We prefer 45 degree blade over 60 degree.
6. Experiment with your cutter to see what settings work best

Add dimension and texture to any graphic design with 3D Xpand. When heat applied, 3D Xpand puffs up to create a unique bubbly texture to letters and shapes. Create authentic applique looks without using embroidery. Great for retro vintage looks.

Try it for numbersing sports uniforms or on novelty or fashion shirts. Create special effects for a design with a snowman, clouds, or bubbling froth on top of a beverage. Ideal for mixed media such as applique or screen printing.

Always test cut to ensure proper depth, speed and down force. ThermoBanner™ is a relatively thick material and requires a different cutting procedure than other Specialty Materials films for optimum cutting and weeding . Reduce the cutting speed and adjust the blade depth to produce accurate cutting. Using a 60° blade can also improve cutting. If slipping or buckling occurs, apply application tape along the edges on the bottom side of the material to increase thickness between the pressure rollers.

You can also apply ThermoBanner™ with a hand held iron or heat gun. ThermoBanner™ requires a medium amount of pressure to insure adhesion. If you are attempting to apply with an iron or heat gun, assistance will be needed. After one person applies sufficient heat to activate the film's hot-melt adhesive, the other person should immediately place pressure on the film with a towel.

Let cool completely before removing carrier sheet. Peel cold.

Please remember: This is a thicker material so it is especially important to perform test cuts before final plotter cutting of your image.