Provides
many features found in
more expensive laminators:
•
Heavy duty motor
• Automatic
take up shaft
• Shaft
for liner paper in front
• Silicone
covered rollers
• Rugged steel and aluminum construction |
|
| Quikmount
makes laminating easy. Just follow a few simple
steps: |
1.
Insert the hubs into
the laminate
core (all laminate rolls
have
3" cores) |
|
| |
|
2.
Shafts lift easily out
of channels,
so laminate rolls can be
changed
quickly. Collars keep the
rolls
in place on the shaft.
|
|
| |
|
3.
Two pulleys (one is
hidden in
the photo) and a belt drive
the take up shaft
|
|
| |
|
4.
Two knobs set the height
and
pressure of top roller
(it is easy
to set the pressure properly)
Accepts boards up to 1"
thick.
|
|
| |
|
5.
Thread liner paper (from
front
shaft) between the rollers.
This
will keep the laminate
from
sticking to the rollers
while
laminating.
|
|
| |
|
6.
Tape release paper (from
back of laminate) to core
on take up shaft.
|
|
| |
|
7.
Thread laminate through
rollers. |
|
| |
|
8.
Run your print through
the rollers. |
|
| |
|
| After
the print exits out the back, go to the back
of the laminator, cut off the laminate, trim
and you have a perfectly laminated print.
You can then simply run through the next print
without going through any more set up since
the laminate and liner paper are already threaded
through the rollers. |
|
Options
|
Stand
Rolling stand is made from
steel with four castors. It makes your Quikmount
4 mobile, while saving table space. Silver
entry deck is 37" high when placed on stand. |
|
| |
|
Footswitch
Footswitch
provides hands free control. |
|
| |
|
|
Mounting
|
| Apply
mounting adhesive |
| Place
a roll of mounting adhesive on the back shaft
(for most adhesives you do not need the take
up shaft). Run your board through to apply
adhesive. It comes out with a release paper
covering the adhesive on the board so you
can use it at any time. |
| Mount
prints to boards |
Pull
back the first two inches of the release liner
covering your board or media to expose the
adhesive. Position your print on the board,
then rub down the first two inches to the
exposed adhesive.
Place the board/print into the Quikmount rollers,
drape the print over the top roller (as shown
in photo) and run it through the rollers.
You get a smooth mount every time. |
|
Specifications
|
|
Roller Widths
|
|
25",
38", 55" or 65"
|
|
Board Thickness
|
|
up to 1" thick
|
|
Speed
|
|
8
seconds per foot
(or 7.5 ft. per minute)
|
|
Electrical
|
|
110
volt (U.S.) or
230 volts (for overseas)
|
|
Outside
Dimensions
|
25"
|
17"
W x 31" L
|
|
38"
|
17"
W x 44" L
|
|
55"
|
17"
W x 61" L
|
|
65"
|
17"
W x 71" L
|
|
